WikiNano.
Panama Canal Lock Simulator
Gatun Locks · Atlantic side · 9°16′N 79°55′W

How a 65,000-tonne ship climbs 26 metres with no pumps

The Panama Canal is a water staircase. Every lift is done by gravity: water runs downhill through culverts until two levels match. This working model solves the real hydraulic equations as you operate the gates and valves.

Operate the locks

Numbered posts are the mitre gates. The pipe under the floor is the culvert system, with a valve (V) below each gate and ports opening into each chamber floor. Red wedges show net water pressure on a closed gate.

Next step

Elapsed time
00:00
simulated min:sec
Ship height above sea
0.0 m
Atlantic
Head across gate 1
0.0 m
Δh = h₁ − h₂
Water speed in culvert
0.0 m/s
v = C·√(2gΔh)
Culvert flow
0 m³/s
Q = a·v
Net force on gate
0 MN
½ρg·w·(h₁² − h₂²)
Ship draught
11.7 m
under keel 2.8 m
Lake water released
0 m³
ship energy gained 0.0 GJ

Water level in each chamber over time

Each curve flattens as it approaches its target because flow falls with the square root of the remaining head. Hover the chart to read values.

The physics the model solves

1. Torricelli's law drives the flow

v = Cd·√(2·g·Δh)    Q = a·v

Water leaving a tank under a head Δh reaches the speed it would gain falling that height. Friction and bends in the culverts cut this by a discharge coefficient Cd. With a 17.3 m head and two 5.5 m culverts the model peaks near 390 m³/s, enough to fill an Olympic pool in about 6 seconds.

2. Levels change fast, then slowly

dh/dt = Q / A    T = 2·A·√Δh₀ / (Cd·a·√(2g))

Dividing flow by the chamber's plan area A gives the rate the surface moves. As the head shrinks the flow shrinks, so the level follows a parabola in time. Filling from the lake takes about 10½ minutes here. Swapping water between two chambers takes half the formula's time, about 7½ minutes, because one falls while the other rises. The real locks take roughly 8.

3. Hydrostatic pressure locks the gates

p = ρ·g·h    F = ½·ρ·g·w·(h₁² − h₂²)

Pressure grows linearly with depth, so the load on a gate is a triangle, widest at the sill. With chamber 2 full and chamber 1 empty the net force on gate 2 is about 73 MN, the weight of roughly 7,400 tonnes. The two leaves meet in a V pointing upstream, so this force wedges them tighter. Once levels match, the net force is zero and a small motor can swing them.

4. Archimedes carries the ship

mship = ρ·Vdisplaced    E = m·g·H

The ship floats where it displaces its own mass of water, so it rides the surface up with no force applied to the hull. Fresh lock water is 2.4% less dense than the sea, so the ship sits about 0.3 m deeper after gate 1. Raising 65,000 t by 26 m adds about 16.6 GJ of potential energy. No motor supplies it: an equal weight of water moves down as the ship moves up.

Model parameters

QuantityValueNote
Chamber length × width304.8 × 33.53 mThe original 1,000 × 110 ft chambers. Plan area A = 10,220 m².
Lift per step8.67 mThree equal steps to the 26 m lake. Real steps vary with tide and lake level.
Culvert area, a47.5 m²Two main culverts, each 5.5 m in diameter.
Discharge coefficient, Cd0.45Assumed. Chosen so the fill time lands near the real 8 minutes.
Valve travel, gate swing1 min, 2 minValves open gradually, which limits the surge on the ship.
Water density, ρ1000 / 1025 kg/m³Fresh in the chambers and lake, salt in the Atlantic approach.
Ship65,000 t, 12.0 m draughtAssumed Panamax container ship, drawn at 90% of chamber length.
Depth over sills12.8 mThe model stops draining a chamber before the ship would touch the floor.

This is a teaching model. It treats each chamber as a simple tank and lumps all friction into one coefficient, so read its numbers as the right order of magnitude, not survey data.

The whole crossing in profile

The simulator covers the first three steps. The Pacific side splits its three steps across two sites, with small Miraflores Lake between them.

Atlantic · 0 m Gatun Locks3 steps up Gatun Lake · 26 m Culebra Cut 1 step downPedro Miguel Miraflores Lake Miraflores2 steps down Pacific · 0 m about 82 km end to end

Facts worth knowing

1914Opened on 15 August, with the steamer SS Ancon making the first official transit.
82 kmLength from deep water to deep water. A transit takes roughly 8 to 10 hours.
26 mHeight of Gatun Lake above sea level. Every ship climbs it and descends it again.
~200 million LFresh water released to the oceans by one transit through the original locks, about 52 million US gallons.
Same water, any shipA lift needs chamber area × rise, whatever the ship's size, because the ship displaces the same volume before and after.
~660 tWeight of the heaviest gate leaves. They are hollow and partly buoyant, which takes load off the hinges.
MulesElectric locomotives on the lock walls hold ships centred with cables. The ship moves under its own power.
~13,000 kmDistance saved between New York and San Francisco compared with sailing around Cape Horn.
2016Larger Neopanamax locks opened: 427 m long, 55 m wide, with sliding gates and basins that reuse about 60% of the water.
36 centsThe lowest toll ever paid. Richard Halliburton swam the canal in 1928 and was charged by his weight.
East to the PacificBecause the isthmus bends, the canal runs north-west to south-east. Its Pacific end lies east of its Atlantic end.
Rain-fedGatun Lake is refilled only by rainfall and the Chagres River, so droughts force limits on ship draught and daily transits.

About Panama Canal Lock Simulator

Operate the Gatun Locks yourself: open valves and gates and watch gravity lift a 65,000-tonne ship 26 metres, with the real hydraulics, the whole canal crossing in profile and key facts.

Topic: Panama Canal locks and hydraulics · Format: interactive simulator · Free, no sign-up · Updated 2026-11-17 · By Prince Vincent, WikiNano · Last reviewed 2026-11-17.

Inside this page

Common questions

Does the Panama Canal use pumps to lift ships?
No. Every lift is done by gravity: water from Gatun Lake runs downhill through culverts under the lock floor until the levels in two chambers match. The ship floats up with the water.
How much water does one transit use?
About 200 million litres of fresh water through the original locks, released to the oceans. The amount depends on the chamber area and the rise, not on the size of the ship. The 2016 Neopanamax locks reuse about 60% of their water.
How long is the canal and how high does it go?
About 82 km from deep water to deep water, climbing to Gatun Lake 26 m above sea level. A transit takes roughly 8 to 10 hours.

Keep exploring